Wiring from busbar | Electroluminescent store (EN)
156
single,single-portfolio_page,postid-156,ajax_fade,page_not_loaded,,vertical_menu_enabled,side_area_uncovered_from_content,qode-theme-ver-13.0,qode-theme-bridge,wpb-js-composer js-comp-ver-5.4.5,vc_responsive
 

Wiring from busbar

Do It Yourself

Expert

Date
Category
Film, Paint
About This Project

There should be an unobstructed table to solder the wiring between busbar and inverter. Stay protected in a quiet and bright location.
Besides iron soldering and tin wire, you'll need additional tools:

  • One iron holder and a small wet sponge to clean the soldering iron
  • One small vise is very convenient
  • One side cutter and wire stripper may also be on the table
  • The place should be well ventilated because the fumes from welding are toxic.

It will be important to get the power cable to the back of the table avoid as much accidental contact with the soldering iron.

No Comments

Post A Comment