Car wrapping installation

For large areas

• Once your cut wrapping is positioned with its margin, it will fall back on to itself in order to have the 2 halves on the right side
• Then, peel liner from angles to the opposite side
• Cut the liner in the middle. Do not scratch the electroluminescent film or body. You end up with the folded film glue up on the right side
• To prevent dusts from the cut during installation, simply use a microfiber to remove it
• Stick liner above the electroluminescent film within the limits of the lamp
• Now unfold the wrapping film to entirely install on the body, then pass the squeegee on this area
• Peel off the liner slowly (starting out by where you cut / folded) and move towards the outside while squeegee the film
• Make sure the electroluminescent lamp turn on and the wrapping film are aligned